A bit more work

It’s been freezing cold recently. I did manage to get the other window seal installed. I also got the front valence assemblies down from the attic and removed the turn signal lamps and some grille trim from them. A few of the screws were too rusted to unscrew, so I had to drill them out. The valences each have a spot where there was some rust-thru. They will be a bit tricky to repair, since they have a two-layer construction with a gap between the two pieces of sheet metal, and the low spot rusted out from the inside, It is a funny place to rust out, since it was not exposed to much splay or road spray, but the inside surfaces of the metal apparently never got any paint or rust protection at the factory.

Comments are closed.