Finishing the seatbacks

I cut lots of pieces of styrofoam insulation and put them in the buoyancy chambers. I also primed and painted the storage compartments at the rear. Next I glued the seatback panels into place. They are held in place with clamps, stainless-steel pneumatic brads, and a couple of weights. The last step was to glue down the top pieces.

The transom skirt, and steam-bending

I installed the transom skirt:


I decided that the forward sheerclamps were too stiff to successfully bend into place, so I decided to steam them first. I made a minimalist steam box from an empty paint can and seven feet of “spa vacuum hose” from Lowe’s. For a heat source, I naturally used the same LP gas burner I got for the lead-melting. After an hour of steaming, each sheerclamp bent easily, and I clamped them to the outside of the hull to dry out for a few days.